4:24 AMError codes Bosch washer
F01 - Error loading hatch. -The door is not properly closed, or something fell between the seal and the hatch.
F02 - No water comes into the drum
F03 - Water drains
F04 - Leaking tank on the pallet
F16 - charging port is not closed
F17 - The time limit for filling the tank with water exceeded. Unlike F02, water enters the tank, but very slowly.
F18 - The time limit for the water drain is exceeded. Unlike the F03, drain made, but very slowly.
F19 - Error when heated. - Washing is continued without heating the water.
F20 - The unauthorized incorporation of PETN.
The machine is switched off. It is necessary to contact with the master.
F21 - Error drive motor
F22 - Error temperature sensor
F23 - Activated mode "Aquastop" - Detected water leakage
F25 - Error Sensor Water Quality
F26 - Pressure sensor error - The machine stops and blocks access to water. It is necessary to contact with the master.
F27 - The pressure sensor is not calibrated. - Most often, this means that the sensor is reset and it will work on any available stock.
F28 - Pressure sensor error in the survey systems.
F29 - Error stream - The work does not stop.
F31 - Water level error. Exceeding the maximum allowable value.
F34 - Error access door - Faulty locking mechanism
F36 - A mistake by the locking mechanism of the control circuit
F37 F38 - Defective temperature sensor
In the case of F38 - short circuit.
F40 - mains parameters do not correspond to normal values.
F42 - Engine speed exceeded the maximum allowable value.
F43 - No rotation of the drum
F44 - No engine speed to one side. Reversing error.
F59 - Error 3D sensor
F60 - Pressure incoming error. - Too high a pressure in the water network. It is possible to fix the valve partially closed.
F61 - Error door in the survey systems.
F63 - Error protection
F67 -Invalid card code
E02 - Faulty motor
E67 - Error basic module
|Total comments: 0|